This versatile watch cleaning machine is very useful for polishing and scratch removing all kind watch flat crystals
Made of high quality material for strength and durability
Easy to use and completely reliable
The medium also has a heater and 5 speed regulator (Include 3 Glass Jars and 1 Basket set)
Watt/Voltage: 220 and 110 Available

Solidly constructed from high class material with highly chrome-plated- spring Ioaded self-centering column with handle.
Robustly built, self lubricating noiseless motor of A.C. Current suitable for 220-230 Volts. Also available in 110 volts.
Stainless steel basket with a capacity for cleaning four watches at a time without mixing the parts.
Enclosed heater which gives no direct heat during drying process thereby not effecting the hair spring and the main spring.
Two separate switches for controlling the heater and the motor.
Red pilot lamp to indicate the heater while it is on. Every machine is carefully tested before dispatch.
Consumption: - Motor 40 Watts. Heater 100 Watts Approx.
Over All Dimension: Height 1’-7½” Base Dia 1'½" Weight 8.250 Kgs. (approx.)

GUIDE TO BETTER CLEANING
Fill the JAR No.1 with any good make of solution and second and third Jars with Petrol.
Fill the Jar's about two-third, so that the basket should be entirely immersed in the solution. If the basket is not entirely immersed in the solution it will produce undue foam or leather.
Dismantle all the parts of the Watch and put them into the basket. Do not remove the hair-spring from the Balance Wheel. Place the large parts in the large Bottom Basket and smaller parts in the small compartments provided in the upper basket. Do not place small and delicate parts with large-ones to avoid breakage. Place the cover on the top.
Attach the basket to the Motor, Immerse the basket in Jar No.1 containing watch Cleaning solution: start the Motor as well as Heater by means of Switches provided in the machine. In this way by the time the Basket is ready for drying chamber, the maximum heat will have been obtained.
Rotate the basket in the JAR No.1 for 2 to 3 minutes, than raise the basket a little above the solution and let it spin for a few seconds long enough to throw off the surplus solution. Next immediately immerse the Basket in Jar No.2 containing Petrol, rotate the basket for 2 or 3 minutes then raise the basket, throw off surplus Petrol as before, place the basket into the Third JAR containing petrol. Perform the same operation and transfer the basket to the heating Chamber for five minutes low speed. Now the Watch-parts are ready for assemble.

ATTENTION
Always use three pin plugs (which is a must)
Before transferring the basket from one Jar to the other quickly spin off as much solution as possible, as this will minimize contamination of your petrol and will increase its life.
Whenever the solution is changed the Jars should be' thoroughly cleaned
Machine should be cleaned from inside from time to time. The Centre Column should not be greased or oiled and should be kept clean and dry, as this will mini mise wear and tear and will make easy up and down. Movement of the motor bracket.
Upper bush of the motor should be oiled twice a year with good quality mobile oil.
The proper functioning of the regulator can only be checked when the basket is in the solution or petrol.
After 50-60 cleaning of watches the solution should be replaced.